Episode ESA-70V2CH-150W User Manual

page | 8
POSITIONING THE AMPLIFIER
Placing the amplifier can have a large impact on performance and longevity. Please take the
following guidelines into consideration.
Shelf Mounting
• Be sure that the unit is in a well-ventilated area that provides adequate cooling.
• Do not block the cooling vents located on both sides of the unit.
• Do not place the unit on carpeting or any similar material.
• Do not install the unit near a source of heat, or in an extremely humid or wet location.
• If your installation lacks good air flow (such as solid cabinet doors or wall-mounted
racks), it may be necessary to create ventilation to allow outside air into the space.
• A minimum of 2” of free space should be allowed above and below the unit for optimum
performance.
EA-AMP-SUB-1D-150
Minimum of 2" of free air
space above

Episode ESA-70V2CH-150W Specifications

General

Power Output	150W
Channels	2
Impedance	4-8 Ohms
Frequency Response	20Hz - 20kHz
Total Harmonic Distortion (THD)	<0.1%
Signal-to-Noise Ratio	>90dB
Input Impedance	10k Ohms
Cooling	Convection
Input Sensitivity	0.775V (0dBu)