3. Select Auto Calibration and press Enter.
4. Adjust the focus if necessary, by opening the cover on the side of the projector and sliding the focus
lever.
5. Press Enter to select Yes.
A pattern appears then disappears, and the system is calibrated. If you see a message that
calibration failed, you need to calibrate manually.
The cursor location and pen position should match after calibration. If not, you may need to calibrate
manually.
Parent topic: Using the Pens
Related tasks
Calibrating Manually
Calibrating Manually
If the cursor location and pen position do not match after auto calibration, you can calibrate manually.
133
To Next Page
Loading...
