5. Select the following options for emailing as necessary:
• SMTP Server lets you enter the mail server address for sending emails from the projector. If you
don't know this information, check with your IS department or ISP.
• Port Number lets you enter a port number for the SMTP server. The default port is 25.
• Reply to lets you enter an email address to use when an error occurs while sending an email. You
can enter up to 64 alphanumeric characters.
• Default e-mail address lets you enter an optional address for testing. You can enter up to 64
alphanumeric characters.
• Send a test e-mail connects to the SMTP server and sends a test email to the address you set as
the default.
Note: Use the displayed keyboard to enter the addresses. Press the arrow buttons on the remote
control to highlight numbers or characters and press Enter to select them.
6. When you finish selecting settings, select Setup Complete and follow the on-screen instructions to
save your settings and exit the menus.
Parent topic: Selecting Whiteboard Settings
Related tasks
Emailing Your Whiteboard Pages
Inserting a Document or Image From a Scanner
You can scan a paper document into a new page in whiteboard mode. Make sure a supported Epson all-
in-one printer is connected to the control pad (or to your network).
Note: Standalone scanners are not supported.
1. Place your document on the scanner glass or in the automatic document feeder (if available).
Note: You can place up to 10 sheets in the ADF. If you want to scan a longer document, scan the
pages in batches of 10.
2. Select the Scan tool on the bottom toolbar.
You see the Scan screen:
154
To Next Page
Loading...
