Note: To use computer interactive mode wirelessly, you need to install Easy MP Network Projection
software, version 2.81 (or later), or Quick Wireless version 1.31 (or later).
You can also do the following in computer interactive mode:
• Use the Tablet PC input panel in Windows 7 or Windows Vista
• Use Ink Tools for annotation in Microsoft Office applications
Switching to Computer Interactive Mode
Adjusting the Pen Operation Area
Parent topic: Using the Interactive Pens
Related concepts
Windows Pen Input and Ink Tools
Network Interactivity
Switching to Computer Interactive Mode
You can easily switch between annotation and computer interactive modes. Although you can use both
pens in computer interactive mode, this may cause interference in some applications. To avoid
interference, turn off the unused pen or move it away from the projection surface.
• To switch to computer interactive mode, select the Pen mode icon on the toolbar, then select the
Mouse icon.
• To switch back to annotation mode, select the Mouse icon, then select the Pen mode icon.
Parent topic: Computer Interactive Mode
Related tasks
Using the Pens
Adjusting the Pen Operation Area
The pen operation area is normally adjusted automatically if you connect a different computer or adjust
the computer's resolution. If you notice that the pen position is incorrect, you can adjust the pen area
manually.
Note: Manual adjustment is not available when projecting from a LAN source.
169
To Next Page
Loading...
