Use envelopes that are
❏ Envelope C6 or Envelope DL size (Other envelope sizes are not supported.)
❏ Common office envelopes approved for laser printing with diagonal joints, sharp folds and edges,
and ordinary gummed flaps
Note:
Because the envelopes pass through heated rollers, the gummed area on the flaps may seal. Using
envelopes with emulsion-based glue avoids this problem.
❏ Approved for laser printing
❏ Dry
DO NOT use envelopes that have
❏ Sticky flaps
❏ Tape seals, metal clasps, paper clips, fasteners, or peel-off strips for sealing
❏ Transparent windows
❏ Too rough of a surface
❏ Material that will melt, vaporize, offset, discolor, or emit dangerous fumes
❏ Been presealed
Label
A sheet of labels consists of a face sheet (the printing surface), adhesive, and a carrier sheet:
❏ The face sheet must follow the plain paper specification.
❏ The face sheet surface must cover the entire carrier sheet, and no adhesive should come through
on the surface.
You can print continuously with label sheets. However, this could affect the media feed, depending on
the media quality and printing environment. If problems occur, stop the continuous printing and
print one sheet at a time.
Try printing your data on a sheet of plain paper first to check placement. Check your application
documentation for more information on printing labels.
AcuLaser C1600 User’s Guide
Media Handling 29
To Next Page
Loading...
