About the Rotate Toner KEY
The Rotate Toner key allows you to switch the printer from normal operation mode to Change Toner
mode, Eject All Toner mode or Print Head Cleanup mode.
The mode that the printer enters depends on how long the Rotate Toner key is held down.
Length of time that the Rotate
Toner key is held down
Mode that the printer enters Indicators on the control panel
Less than 5 seconds Change Toner mode -
5 to 9 seconds Print Head Cleanup mode All indicators blink once after the key
has been held down for 5 seconds.
More than 10 seconds Eject All Toner mode All indicators flash once after the key
has been held down for 10 seconds.
Note:
When the printer is switched to any of these operation modes, the magenta toner indicator lights up.
The Rotate Toner key is used in the following situations.
❏ When replacing a toner cartridge
❏ When removing all toner cartridges
❏ When cleaning the print head window
When replacing a toner cartridge
Press the Rotate Toner key.
The printer enters Change Toner mode.
Note:
❏ For details on replacing a toner cartridge, refer to “Replacing a Toner Cartridge” on page 39.
❏ To return to normal operation mode from Change Toner mode, press the Clear key.
When cleaning the print head window
Hold down the Rotate Toner key for 5 seconds to 9 seconds.
The printer enters Print Head Cleanup mode.
AcuLaser C1600 User’s Guide
Introduction 11
To Next Page
Loading...
