Epson Aculaser C1600 - Service Message

Ready
indicator
(green)
Error
indicator
(orange)
Toner
indicator
(orange)
Display of
Remote
Panel
Program
Condition Action
Off Blinking * TOP COVER
OPEN /
CLOSE TOP
COVER
Front cover or top cover
is open.
Close the front cover
and top cover.
The photoconductor
unit is not installed.
Install the
photoconductor unit.
Off Rapid
blinking
* TRANSFER
JAM, FUSER
JAM,
OUTPUT
JAM / OPEN
TOP COVER
Media jam Clear the jam, close the
covers, and then
continue with the print
job.
PROCESS
ERROR-BELT
, PROCESS
ERROR-IDC
Process error Open and close the
printer’s covers.
If the error is not
corrected, turn off the
printer. After a few
seconds, turn on the
printer.
Off On All blinking P/U LIFE
END
Photoconductor unit
end
Replace the
photoconductor unit.
* Differs depending on the toner status.
Service Message
This message indicates a more serious fault that can only be corrected by a customer service engineer.
Ready
indicator
(green)
Error
indicator
(orange)
Toner
indicator
(orange)
Display of
Remote
Panel
Program
Condition Action
Rapid
blinking
Rapid
blinking
All blinking SERVICE
CALL(XXXX)
Fatal error Turn off the printer. After
a few seconds, turn on
the printer.
If the problem persists,
contact your vendor or
authorized service
provider.
AcuLaser C1600 User’s Guide
Troubleshooting 72