Epson Aculaser C1600 - Page 69

Ready
indicator
(green)
Error
indicator
(orange)
Toner
indicator
(orange)
Display of
Remote
Panel
Program
Condition Action
On Off On TONER OUT
X (YMCK)
Toner out
Note:
This message appears
when the Toner Out
Stop in the Remote
Panel Program is set to
Off.
Replace the toner
cartridge.
Note:
Printing can continue,
however, the printing
results are not
guaranteed.
If printing is continued,
the Error indicator
(orange) lights up and
printing stops.
On Slow
blinking
Rapid
Blinking
NON
GENUINE
TONER X
(YMCK)
The installed toner
cartridge is of an
unapproved type.
Install a Epson toner
cartridge of the
appropriate type.
See “About Toner
Cartridges” on page 38.
On Slow
blinking
* P/U LOW Photoconductor unit
near end
Prepare the new
photoconductor unit.
*T/C
MEMORY
ERROR
Toner cartridge memory
error
Re-install the specified
toner cartridge.
* VIDEO I/F
ERROR
Video interface error Turn off the printer. After
a few seconds, turn on
the printer.
*PROCESS
CAUTION-ID
C
Process caution Open and close the
printer’s covers.
If the error is not
corrected, turn off the
printer. After a few
seconds, turn on the
printer.
AcuLaser C1600 User’s Guide
Troubleshooting 69