Assembling the Printer
15
❏ When installing the photoconductor unit, avoid exposing it
to room light more than five minutes. The unit contains a
light-sensitive drum. Exposure to light can damage the drum,
causing dark or light areas to appear on printouts and
reducing the service life of the drum. If you need to keep the
unit out of the printer for long periods, cover it with an opaque
cloth.
❏ To get the best print quality, do not store the photoconductor
unit in an area subject to direct sunlight, dust, salty air, or
corrosive gases (such as ammonia). Avoid locations subject to
extreme or rapid changes in temperature or humidity.
❏ Keep the photoconductor unit out of the reach of children.
❏ Do not tilt the photoconductor unit. Otherwise, the toner will
spill out and may reduce the print quality.
To install the photoconductor unit, follow the instructions below.
1. Press the latch on cover A and open the cover.
To Next Page
Loading...
