Safety Instructions
3
❏ Do not put your printer where the cord will be stepped on.
❏ Avoid using outlets that other appliances are plugged into.
❏ Slots and openings, located on the sides of the printer, are
provided for ventilation. Keep these slots and openings clear
to allow proper ventilation. Avoid placing the printer on a soft
surface like a bed or a sofa, or in a small enclosed area, as this
restricts ventilation.
❏ The interface connector for this printer is Non-LPS
(non-limited power source).
❏ When using an extension cord, be careful not to exceed its
recommended amperage limit. Also, be sure that all items
plugged into the electrical outlet do not exceed a total of 15
amperes.
❏ Never push objects of any kind through cabinet slots as they
may touch dangerous voltage points or short out parts that
could result in fire or electric shock.
❏ Never spill liquid on the printer.
❏ Unless specifically instructed in this guide, do not attempt to
service this product yourself. Opening or removing covers
that are marked Do Not Remove exposes you to dangerous
voltage points and other risks. Refer all servicing in those
compartments to a qualified service representative.
❏ Adjust only those controls that are covered by the operating
instructions. Improper adjustment of other controls may
result in damage and may require repairs by a qualified
service representative.
❏ Unplug the printer and refer servicing to a qualified service
representative under the following conditions:
A. If liquid has entered the printer.
B. If the printer has been exposed to rain or water.
To Next Page
Loading...
