Epson Artisan 810 - PF Adjustment

Epson Artisan 810/835/837/710/725/730/Epson Stylus Photo PX810FW/TX810FW/PX820FWD/TX820FWD/PX830FWD/PX710W/TX710W/PX720WD/TX720WD/PX730WD/TX730WD Revision G
ADJUSTMENT Adjustment Using Adjustment Program 216
Confidential
5.2.5 PF Adjustment
 PF-Standard Area
Patterns are printed as shown below.
Figure 5-6. PF Adjustment (Standard Area) Pattern
How to Judge
Enter the value for the group that has no gap or overlap between the upper and the
lower patterns.
 PF-Bottom Edge Area
Patterns are printed as shown below.
Figure 5-7. PF Adjustment (Bottom Edge Area) Pattern
How to Judge
Input the value shown above the patterns which has no gap between the upper pattern
and the lower pattern, and also the both upper and lower patterns do not overlap each
other.
Example: In the above figure, patterns below “4” has no gap and overlap, so input “4”.
Additional information
In case that all patterns have gap or overlap, select the value for the pattern which has
the least gap or overlap, and print the pattern again.
C H E C K
P O I N T
Example for judgement
-1
3
2
-2
0
1
4
OK
NG
NG
C H E C K
P O I N T
Example for judgement
23456781
Upper block
Lower block
OK NGNG
Gap
Overlap