Epson Artisan 810 - Decoration Plate Left Upper Sub

Epson Artisan 810/835/837/710/725/730/Epson Stylus Photo PX810FW/TX810FW/PX820FWD/TX820FWD/PX830FWD/PX710W/TX710W/PX720WD/TX720WD/PX730WD/TX730WD Revision G
Artisan 837/730/PX830FWD/PX730WD/TX730WD Disassembly/assembly 293
Confidential
9.4.2.1 Decoration Plate Left Upper Sub
 Parts/Components need to be removed in advance:
None
 Removal procedure
1. Remove the screw (x1) that secures the Decoration Plate Left Upper Sub.
Figure 9-4. Removing the Decoration Plate Left Upper Sub (1)
2. Open the Panel Unit.
3. Insert the flathead screwdriver into the gap between the Decoration Plate Left
Upper Sub and Upper Housing as shown in
Fig. 9-5, and lift the Decoration
Plate Left Upper Sub to release the ribs (x2) of the Upper Housing.
4. Remove the Decoration Plate Left Upper Sub to the rear of the printer.
Figure 9-5. Removing the Decoration Plate Left Upper Sub (2)
C H E C K
P O I N T
This section describes the disassembly/reassembly procedures of the
Decoration Plate Left Upper Sub for Artisan 837/PX830FWD.
The disassembly/reassembly procedures for Artisan 730/PX730WD/
TX730WD differ from those for Artisan 837/PX830FWD, therefore,
see
"9.4.2.16 Decoration Plate Left Upper/Decoration Plate Left
Upper Sub" (p.308) for the procedures.
C.B.P. 3x10 (6±1Kgfcm)
Decoration Plate Left Upper Sub
Decoration Plate Left Upper Sub
Rib
Panel Unit
Upper Housing