Epson Artisan 810 - Rear Left Housing

Epson Artisan 810/835/837/710/725/730/Epson Stylus Photo PX810FW/TX810FW/PX820FWD/TX820FWD/PX830FWD/PX710W/TX710W/PX720WD/TX720WD/PX730WD/TX730WD Revision G
Artisan 837/730/PX830FWD/PX730WD/TX730WD Disassembly/assembly 313
Confidential
9.4.2.19 Rear Left Housing
 Parts/Components need to be removed in advance:
Scanner Unit/Decoration Plate Left Upper/Decoration Plate Left Upper Sub/Paper
Guide Top Assy/Upper Housing
 Removal procedure
1. Remove the screws (x2) that secure the Rear Left Housing and remove the
Rear Left Housing.
Figure 9-53. Removing the Rear Left Housing
 Before installing the Panel Unit, insert the Panel FFC Cover
into the hole of the Upper Housing.
Figure 9-52. Installing the Panel Unit
A D J U S T M E N T
R E Q U I R E D
 After removing/replacing the Panel Unit, make the specified
adjustments. (See
"9.5 Adjustment" (p.321).)
 After replacing the Panel Unit, be sure to perform the required
lubrication. (See
Chapter 6 "MAINTENANCE".)
Upper Housing
Panel Unit
Panel FFC Cover
Hole of Upper Housing
C H E C K
P O I N T
This section describes the disassembly/reassembly procedures of the
Rear Left Housing for Artisan 730/PX730WD/TX730WD.
The disassembly/reassembly procedures for Artisan 837/
PX830FWD differ from those for Artisan 730/PX730WD/
TX730WD, therefore, see
"9.4.2.4 Rear Left Housing" (p.297) for
the procedures.
When installing the Rear Left Housing, insert the ribs (x2) of the
Rear Left Housing to the inside of the Left Housing. (See
Fig. 9-53.)
C.B.A. 3x6 (6±1Kgfcm)
Left Housing
Rear Left Housing
Rib