Epson Artisan 810 - Rear Right FAX Housing

Epson Artisan 810/835/837/710/725/730/Epson Stylus Photo PX810FW/TX810FW/PX820FWD/TX820FWD/PX830FWD/PX710W/TX710W/PX720WD/TX720WD/PX730WD/TX730WD Revision G
Artisan 837/730/PX830FWD/PX730WD/TX730WD Disassembly/assembly 299
Confidential
9.4.2.6 Rear Right FAX Housing
 Parts/Components need to be removed in advance:
ADF Unit/Scanner Unit/Decoration Plate Left Upper Sub/Paper Guide Top Assy/
Upper Housing/Hinge
 Removal procedure
1. Remove the screws (x3) that secure the Rear Right FAX Housing.
Figure 9-17. Removing the Rear Right FAX Housing (1)
2. Release the hook A in Fig. 9-17, and also release the ribs (x2) on the right side
and hook B in Fig. 9-18, then remove the Rear Right FAX Housing by lifting
it in the direction of the arrow.
Figure 9-18. Removing the Rear Right FAX Housing (2)
C H E C K
P O I N T
This section describes the disassembly/reassembly procedures of the
Rear Right FAX Housing for Artisan 837/PX830FWD.
The disassembly/reassembly procedures for Artisan 730/PX730WD/
TX730WD differ from those for Artisan 837/PX830FWD, therefore,
see
"9.4.2.20 Rear Right Housing" (p.314) for the procedures.
C.B.A. 3x8 (6±1Kgfcm)
C.B.S. 3x6 (5±1Kgfcm)
C.B.P. 3x10 (6±1Kgfcm)
Hook A
Rear Right FAX Housing
 When installing the Rear Right FAX Housing, insert the ribs
(x2) of the Rear Right FAX Housing to the inside of the Right
Housing. (See
Fig. 9-18.)
 When installing the Rear Right FAX Housing, align the point A
of the Rear Right FAX Housing with the inside of the Base
Frame. (See
Fig. 9-18.)
 When installing the Rear Right FAX Housing, be careful not to
let the Power Supply Unit Cable get caught by the point B of the
Rear Right FAX Housing. (See
Fig. 9-18.)
Rib
Rear Right FAX Housing
Right Housing
Point A
Hook B
Point B
Power Supply Unit Cable