Epson Artisan 810 - Rear Left Housing

Epson Artisan 810/835/837/710/725/730/Epson Stylus Photo PX810FW/TX810FW/PX820FWD/TX820FWD/PX830FWD/PX710W/TX710W/PX720WD/TX720WD/PX730WD/TX730WD Revision G
Artisan 837/730/PX830FWD/PX730WD/TX730WD Disassembly/assembly 297
Confidential
9.4.2.4 Rear Left Housing
 Parts/Components need to be removed in advance:
ADF Unit/Scanner Unit/Decoration Plate Left Upper Sub/Paper Guide Top Assy/
Upper Housing
 Removal procedure
1. Remove the screws (x2) that secure the Rear Left Housing and remove the
Rear Left Housing.
Figure 9-14. Removing the Rear Left Housing
 When installing the Decoration Plate Left Upper, align the
dowels (x2) of the Upper Housing with the positioning holes (x2)
of the Decoration Plate Left Upper. (See
Fig. 9-12.)
 When installing the Decoration Plate Left Upper, route the
grounding wire of the Panel Unit through the groove of the
Upper Housing. Be careful not to let it get caught by the Upper
Housing. (See
Fig. 9-13.)
Figure 9-13. Routing the Grounding Wire
Panel Unit
Grounding wire
Upper Housing
Groove
C H E C K
P O I N T
This section describes the disassembly/reassembly procedures of the
Rear Left Housing for Artisan 837/PX830FWD.
The disassembly/reassembly procedures for Artisan 730/PX730WD/
TX730WD differ from those for Artisan 837/PX830FWD, therefore,
see
"9.4.2.19 Rear Left Housing" (p.313) for the procedures.
When installing the Rear Left Housing, insert the ribs (x2) of the
Rear Left Housing to the inside of the Left Housing. (See
Fig. 9-14.)
Rib
Left Housing
Rear Left
C.B.A. 3x8 (6±1Kgfcm)
Rear Left Housing