133
Maintaining and Transporting the Printer | 133
5. Loosen the screw holding the cutter in place, then carefully remove the
cutter from the printer.
6. Dispose of the cutter in accordance with local regulations.
Installing the New Cutter
Remove the new blade from its package, then follow these steps to install it:
1. Insert the new cutter into the holder. Make sure the cutter pin goes into
the hole. Tighten the screw using a cross-head screwdriver.
WARNING: The blade is
sharp. Be careful when
removing it.
SP4900_uguide.book Page 133 Tuesday, December 9, 2014 12:30 PM
To Next Page
Loading...
