152
152 | Solving Problems
Improving Print Quality
You can often improve print quality by doing the following:
• Run a nozzle check and cleaning cycle. See page 120 for instructions.
• Align the print head. See page 125 for instructions.
• When you send a print job, make sure your print options are set
correctly. For more information, see page 61 (Windows) or page 89
(Macintosh).
SPECTROPROOFER ERROR
REFER TO THE MANUAL
AND CONNECT THE ILS20EP
TO SPECTROPROOFER
TURN THE POWER OFF,
AND THEN ON AGAIN
There is an error with the
optional SpectroProofer.
Refer to the SpectroProfer User’s Guide for
additional information.
WRONG SUPPORT
POSITION
LOWER THE PAPER EJECT
SUPPORT
The paper eject support is in
the wrong position.
Lower the paper eject support.
WRONG SUPPORT
POSITION
RAISE THE PAPER EJECT
SUPPORT
The paper eject support is in
the wrong position.
Raise the paper eject support.
Message Explanation Response
To Next Page
Loading...
Need help?
General