19
19
This chapter includes the following information:
• Unpacking and connecting the Epson Stylus Pro 4900
• Installing ink
• Connecting to your computer or network
• Configuring the printer for a network
• Installing the printer software for Windows or Mac
• Updating the printer firmware
Unpacking and Connecting the Printer
Follow these steps to unpack the printer and connect the power cord.
Before you begin, make sure you have sufficient space to set up and use the
printer.
1. Remove the tape from the front of the paper tray.
2. Lift the edge of the output tray to remove it.
Chapter 1:
Setting Up the
Printer
WARNING: The printer
weighs about 115 pounds
(52 kg) and should be lifted
by two people.
SP4900_uguide.book Page 19 Tuesday, December 9, 2014 12:30 PM
To Next Page