Epson DLQ-3500II - Switching between the Tractor and the Cut Sheet Feeder

Follow these steps to load paper manually using the sheet guide:
1. Make sure that Manual/CSF is selected as the paper source on the home screen. If not, select it by
pressing the Paper Source button.
2. Push the sheet guide and the paper support all the way in.
3. Adjust the left edge guide so that it is aligned with the guide mark on the sheet guide.
4. While aligning the left side of paper with the edge guide and adjusting the right edge guide to
match the width of the paper, insert it until it meets resistance. Be sure to load paper printable side
up. After a few seconds, the printer automatically advances the paper to the loading position. The
printer is ready to accept data from your computer and print.
After printing a page of your document, the printer ejects it onto the sheet guide and the Paper Out
and Pause lights come on. If you are printing a multiple-page document, remove the printed sheet
and insert a new sheet into the sheet guide. The printer automatically advances the paper and resumes
printing.
Switching between the tractor and the cut sheet feeder
You can easily switch between continuous paper loaded from the tractor and single sheets loaded from
the cut sheet feeder without removing your continuous paper.
Switching to continuous paper
Follow these steps to switch to continuous paper loaded from the tractor:
1. If any single sheets are in the paper path, press the Load/Eject button to eject them.
2. Select Tractor as the paper source on the home screen by pressing the Paper Source button.
Switching to single sheets
Follow these steps to switch back to single sheets loaded to the cut sheet feeder:
1. If there is any continuous paper remaining in the printer, select Tear Off on the home screen and
press the OK button to advance the paper to the tear off position.
2. Tear off the printed pages.
DLQ-3500II/DLQ-3500IIN User’s Guide
Options and Consumables 117