* 2 mm or less
❏ The binding area should be flat and have no creases.
❏ The sprocket holes of all sheets in the form should be aligned properly.
❏ The binding position should be outside the printable area. See “Printable area” on page 134 for
more information.
Labels
❏ Labels should be securely attached to the backing sheet and the label surface must be flat.
❏ The labels should not peel off their backing sheet under the conditions below.
wrapping drum radius: 27 mm
wrapping angle: 180 ˚
wrapping time: 24 hours
ambient temperature: 40 ˚C
ambient humidity: 30%
1. label
2. 27 mm
❏ When using labels whose backing sheet is entirely covered, make sure the cuts around the edges of
the labels are perforated.
DLQ-3500II/DLQ-3500IIN User’s Guide
Product Information 131
To Next Page
Loading...
