Installation Guide
15
Touch Unit
The following supplied products are necessary when attaching the Touch Unit. Confirm that you have all
items before beginning. When installing the Touch Unit outside the whiteboard, use the supplied Touch Unit
Bracket.
Touch Unit Touch Unit connection cable (approx. 2.8 m)
Markers x2 Infrared deflectors
(approx. 28.5 cm) x8
Spacer for screw hole x3 Label x4 Tape for securing the markers
(approx. 6 cm) x12
When installing the Touch Unit on a non-magnetic whiteboard, prepare three commercially available M4
screws.
Touch Unit Bracket
Installation plate Securing plate
M4 x 10 mm hexagon socket head
cap bolts x2
M4 x 25 mm hexagon socket head
cap bolts x2
M4 x 55 mm hexagon socket head cap
bolt x1
M4 x 70 mm hexagon socket head cap
bolt x1
For the installation plate, you also need three commercially available 4 mm diameter wood screws, or three
M4 anchor bolts.
To Next Page
Loading...
Need help?
General
