Installation Guide
46
c
Connect the cables to the projector
s
"Connecting Devices" p.33
Connect the power cord last.
Use commercially available M4 screws to secure peripheral devices and accessories such as external
tuners to the screw holes in the following figure.
Install the wireless LAN module supplied in the wireless LAN unit module slot.
Adjusting the Position of the Projector
•
Images are not stable immediately after turning on the projector. Wait for at least 10 minutes before adjusting the
image after starting projection.
•
Do not make adjustments using the projector's Keystone function. Doing so may result in a reduction in image quality.
•
When setting up multiple projectors using the batch setup function, perform the batch setup before adjusting the
projected image.
s "Batch Setup Function" p.109
To Next Page
Loading...
