Installation Guide
92
[Unit: mm]
Screw hole cross-section
i
Connect the Touch Unit connection cable that is connected to the projector to the TCH
port on the Touch Unit
Angle Adjustment
This section explains how to adjust the angle of the Touch Unit. For details on angle adjustment, see p.71.
c
•
When two projectors are installed in parallel and you want to use the interactive function, set the multi-
projection interactive features in advance.
s"Multi-Projection settings" p.96
•
Before adjusting the angle, make sure that interactive pen calibration is complete.
s "Calibrating the pen" p.55
To Next Page
Loading...
Need help?
General
