4
Place to Install the Setting Plate
Carry out the power supply wiring work for the installation location of the setting plate in advance.
Install the projector away from other electric devices such as fluorescent lights or air conditioners. Some
kinds of fluorescent lights could interfere with the remote control of the projector.
It is recommended to keep connection cable length less than 20 meters to reduce external noise.
We recommend using stick-on screens or board screens.
When using the Easy Interactive Function, make sure the projector is setup under the following
conditions.
• The projection screen is a rectangular shape without any distortion.
• The projector is tilted at an angle of no more than ± 3
°
vertically and horizontally in relation to the projected screen.
• When using Keystone, the amount of V-Keystone and H-Keystone correction is no more than ±6.
About This Installation Guide
This guide describes how to mount the short-throw projector EB-485Wi/485W/480i/480/475Wi/475W/470 to
a wall using the exclusive setting plate.
To Next Page
Loading...
Need help?
General
