The following indicator status are used during regular operation.
Indicator Projector's Sta‐
tus
Explanation
Power Status Lamp1/
Lamp2
Temp Filter
Blue - On Off Off Off Off
Standby condition
Power is being supplied to the projector. In this status, you can start projecting by pressing the [
] button
on the remote control or control panel.
(Sometimes, when the power cord is unplugged, the power indicator remains lit for a short period, but this
is not a fault.)
Network monitor‐
ing status
The projector is being monitored and controlled over a network (when Standby Mode is set to
Communication On).
If the power cord is disconnected and then reconnected in this status, the power indicator flashes blue.
Blue - On
Blue -
Flashing
Status
varies
Off Off
Warm-up status This is the status immediately after turning on the projector. Warm-up takes approximately 30 seconds
after the lamp turns on.
The [t] button is disabled during warm-up.
Blue - On Blue - On Status
varies
Off Off
Projecting The projector is projecting.
Blue - On
Blue -
Flashing
Off Off Off
Cool down status This is the status immediately after turning off the power. In this status, all buttons are disabled.
Blue -
Flashing
Off Off Off Off
Preparing Network
monitoring
Preparing to monitor and control this projector over a network.
During network monitoring preparation, all button operations are disabled.
Blue - On Blue - On
Blue -
Flashing
Off Off
While the shutter
function activated
The shutter function is activated.
Reading the Indicators
142
To Next Page
Loading...
