Attention
• When projecting with the projector tilted, do not tilt it at more than the
specified angle. This may cause malfunctions or accidents to occur.
Angle of tilt (when a standard lamp is attached)
Do not use the projector upside down.
Using the projector at angles not shown in the illustrations above may
damage it or cause an accident.
For the operating conditions when attaching the lamp unit (for portrait use),
see the following.
s "Notes on portrait projection" p.6
• Once installation is complete, make sure you set the Direction. Otherwise the
lamp's operating life may be reduced significantly.
s "Setting the direction" p.30
• Using the projector at an improper angle or setting the Configuration menu
incorrectly causes malfunctions and shortens the operating life of optical
parts.
Attention
• Make sure there is a gap at least as wide as shown in the following
illustration between the wall and the air exhaust vent and the air intake
vent.
Air exhaust vent Air intake vent
• When setting up multiple projectors, make sure there is a gap at least as wide
as shown in the following illustration between the projectors. Also, make sure
that the heat from the air exhaust vent does not go into the air intake
vent.
• Do not place the projector directly on top of another projector.
Safety Warning and Cautions
5
To Next Page
Loading...
Need help?
General
