c
Select the function you want to perform, then press the [ ]
button.
You can only perform Load Memory and Save Memory when an
image is displayed.
Function Explanation
Load Memory
Loads the saved memory. When you select a
memory and press the [
] button, the settings
applied to the current image are replaced with the
settings from the memory.
Save Memory
The settings for the image currently displayed are
saved as a memory. When you select a memory
name and press the [
] button, the settings are
saved.
Erase Memory
Erases the registered memory. When you select a
memory name and press the [
] button, a
message is displayed. Select Yes, and then press the
[
] button to erase the selected memory. You can
erase all memories from Reset Memory.
s Reset - Reset Memory p.138
Function Explanation
Rename Memory
Changes the memory name. Select the memory
name you want to change, and then press the [
]
button. Enter the memory name using the soft
keyboard.
s "Soft keyboard operations" p.128
When you have finished, move the cursor over
Finish, and then press the [
] button.
When a memory has already been saved, the memory name and its
color mode are displayed.
a
• You can register up to ten types of memory.
• If the mark on the left of the memory name is turned blue, it
means the memory has already been registered. When you
select a registered memory, a message is displayed asking you
to confirm if you want to overwrite the memory. If you select
Yes, the previous settings are deleted and the current settings
are registered.
Memory Function
99
To Next Page
Loading...
