B
During projection, while holding the [ID] button, press the
[Help] button.
Remote Control
When you press the buttons, the current Projector ID is displayed on
the projection screen. It disappears in about three seconds.
Setting the remote control ID
Procedure
A
Set the remote control ID switch to On.
B
While holding the [ID] button, press a number button to select
a number to match the ID of the projector you want to
operate.
s "Checking the Projector ID" p.151
Remote Control
Once this setting has been made, the projector that can be operated by the
remote control is limited.
q
The remote control ID setting is saved in the remote control. Even if
the remote control batteries are removed to replace them and so on,
the stored ID setting is retained. However, if the batteries are left out
for a long time, it is reset to the default value (ID0).
Adjusting the Position of the Projected Image
Adjust the position of the projected image, starting from the adjustments
that have larger corrections.
1. Projector’s position (angle) s p.130
2. Lens shift/Zoom s p.138
3. Geometric Correction
• Quick Corner s p.140
• Point Correction
s p.153
Settings for Multiple Projectors
152
To Next Page
Loading...
Need help?
General
