Useful Functions
53
Connecting with WirelessHD (EH-TW9000W
Only)
Installing and Connecting the WirelessHD Transmitter
You can use the included WirelessHD Transmitter to wirelessly receive image data as well as control signals.
This eliminates the need to connect any cables to the projector, which is convenient when you are unable to
place the projector near your AV devices.
Connect the Transmitter to the HDMI output of any AV device or AV System capable of HDMI playback.
Projector Transmitter Player
c
•
The receiver is located at the base of the intake vent of the projector and therefore cannot receive any
signals directly from the rear. Set up the transmitter so that the front of the projector is facing the
transmitter.
•
A WirelessHD vent is located at the base of the projector. When suspending from a ceiling, make sure
it is setup so that dust does not collect in this section.
s p.12
•
Place the WirelessHD Transmitter on a level surface.
•
You can view the signal strength from the WirelessHD settings menu. s Settings - WirelessHD -
Reception p.62
WirelessHD Settings
Changing the source
Press the button on the remote control to change the
source.
c
When receiving WirelessHD images, make sure Wire-
lessHD is set to On from the configuration menu.
s
Settings - WirelessHD p.62
To Next Page
Loading...
Need help?
General
