Overview of EMP NS Connection
10
Steps for connecting
Use the following steps to connect your computer and projector for
projection with EMP NS Connection. Although "Quick Connection
Mode" and "Advanced Connection Mode" are similar, "Advanced
Connection Mode" has some independent settings. For detailed
procedures, see examples of connecting with "Quick Connection Mode"
starting on the next page.
s
p.11
In the following illustration, you only need to perform the light blue
sections the first time you connect.
Quick Connection Mode
Advanced Connection Mode
Install EMP NS Connection on the computer to be connected
s
p.5
Make network settings on the computer and put it into network
connection status
s
p.11
Normally, when a computer is connected with the network and
used, you do not need to make computer network settings.
Enable the wired LAN
adaptor at "Port
Configurations"
s
Computer documentation
Install the supplied wireless
LAN unit
s
Wireless LAN
Quick Connection Guide
Make network settings on the
projector and put it into
network connection status
s
User’s Guide "Network
Menu (EMP-1825 Only)"
Start EMP NS Connection on the computer and connect with the
projector
s
p.12
To Next Page
Loading...
Need help?
General
