12
Connecting to a Projector on a Network and Projecting
Operating the Projector
Before connecting, put the projector into connection standby status.
Make sure the projector network settings are complete, and the projector
is connected to network equipment such as a network hub via a
commercially available network cable.
A
Press the [t] button on the remote control to turn
the power on.
B
Press the [EasyMP] button on the remote control.
The EasyMP standby screen is displayed.
Operating the Computer
In the following explanations, unless otherwise noted, Windows screen
images are used. You see the same screens even when using Macintosh.
A
Start EMP NS Connection.
Select "Start" - "Programs" (or "All Programs") - "EPSON
Projector" - "EMP NS Connection".
Double-click the "Applications" folder of the hard drive volume in
which EMP NS Connection is installed, and then double-click the
EMP NS Connection icon.
B
Select"Quick Connection Mode" and then click
"OK".
The projector search results are displayed. To always connect using
"Quick Connection Mode", select "Set the selected Connection
Mode as the default mode for future connections".
C
Select the projector you want to connect to, and
then click "Connect".
If the projector you want to connect to is not displayed in the
search results, click the "Automatic search" button. The search
takes about 30 seconds.
For details on the connection screen, see "Using the Connection
Screen". s p.13
Procedure
Procedure
For Windows
For Macintosh
To Next Page
Loading...
Need help?
General
