16
Selecting Channels on an HD Tuner, Cable Box, or Satellite Receiver
You can use the numeric keypad to select pretuned radio stations or the tracks on a CD. If you’ve connected an
HD tuner or other equipment to receive programmed content, use the numeric keypad to enter channels. The
method of entering the digits varies, depending on the type of equipment you’re using—for example, you
might have to press
0 to enter a single-digit number, such as 01. In some case, you may need to press the
ENT (Enter) or SEL (Select) button to enter the digits.
You can also use
CH and (channel up and down) to change channels.
To return to the previously selected channel, press the PREV CH button.
Using the Buttons on the AV Controller
You can use the buttons on the AV controller to control most basic functions.
Note
All these functions are accessible via the remote control.
• ON/STANDBY lets you turn on the AV controller. The controller is on when the light surrounding the
button is blue, and is off (standby) when the light is orange.
•
SOURCE lets you switch between the Ensemble HD system’s DVD player and radio, or select other
equipment you’ve connected to the system. Each time you press the button, the AV controller cycles
through these functions or sources:
DVD player o FM radio o AM radio o Audio 1 port o Audio 2 port o Composite video (CVBS) o
S-video o Component video o HDMI 1 o HDMI 2
ON/STANDBY
button
SOURCE button Playback control buttons
Volu me
control
knob
Eject button
To Next Page
Loading...
