33
Connecting the Audio Cable for the Video Source
Once you’ve connected the video cable, you may need to connect an audio cable in order to combine the
picture with sound. If you’ve connected your device using an HDMI cable, the audio signal is already carried
by the cable, so you don’t have to connect an additional cable. (Make sure HDMI audio is enabled in your
component’s setup menu.) Otherwise, you’ll need to connect an audio cable to one of the ports listed below:
* Connection not required if your video device supports HDMI audio.
Check your video device for the type of audio output port(s) it has available. For best sound quality, use either
the coaxial or optical digital audio port. If your equipment doesn’t have digital audio, use an analog stereo
output port instead. Connect the audio cable to one of the ports shown below:
If you’ve connected to this video port... ...connect an audio cable to one of these ports
HDMI 1 or 2 Coaxial*
Optical*
Component Coaxial
Optical
Analog
S-Video Coaxial
Optical
Analog
CVBS (Composite video) Coaxial
Optical
Analog
Coaxial audio port
(digital audio)
Analog audio port
Optical audio port
(digital audio)
To Next Page
