59
Replacing Remote Control Batteries
If the Ensemble HD remote control isn’t working correctly, check the following:
• Aim the remote control at the top of the screen and try operating the screen. If the remote control works
only when you aim it at the top of the screen but not elsewhere in the room, you may need to replace the
batteries.
•Press the
LIGHT button on the side of the remote control and verify its screen and buttons light up. (You
need to be in a darkened room to see this.) If they don’t light up, replace the batteries.
• Check for a LOW BATTERY message at the bottom of the remote control’s LCD screen.
Follow the steps below to replace the batteries in the remote control.
Note
All user-made settings are stored in non-volatile memory and are preserved when the batteries are taken out.
1 Remove the battery compartment cover on the back of the remote control.
2 Insert 4 AAA batteries as shown below.
3 Replace the cover.
To Next Page
Loading...
