Epson Ensemble HD - Linking Audio and Video Sources

34
Linking Audio and Video Sources
Once you’ve connected the audio and video cables, you need to tell the Ensemble HD system which audio and
video ports to use together. That way, when you select a device with the remote control (VCR, cable, satellite,
etc.), the matching audio and video sources will be automatically used. You link the audio and video sources
together using the Source Assign screen.
Note
The label you assign to a device (e.g. “CABLE”) is what you see on the projection screen when you’re selecting sources. It
doesn’t affect the device names shown on the remote control’s LCD screen.
1 Make sure the MAIN menu is displayed on the remote control. If necessary,
press the
MAIN button.
2 Point the remote control at the screen and press the
MENU button.
You see the Ensemble HD menu screen:
3 Use the d button to highlight
Video, then press the SEL (Select)
button.
4 Use the d button to highlight
Source Assign, then press the SEL
(Select) button.
You see the screen shown below. The video port to which you’ve connected your video equipment is listed
in the left-hand column:
Move
Enter
Exit
Menu
Sel
Video
Language
Preference
Audio
Reset
Audio
Voice
Bass
Treble
Surround
Front Distance
Center Distance
Rear Distance
Test Tone
0 dB
0 dB
0 dB
0 dB
5 ft.
5 ft.
5 ft.
d button
Video Input
HDMI1
HDMI2
Component
S-Video
Composite
Move
Adjust
Exit
Menu
ESC
Return
[Source Assign]
Label
Cable
Sat
HD
DVR
Video
Audio Input
HDMI1
HDMI2
Coax
Optical
Analog