54
Cleaning System Components
You can clean the outside of the system components to remove dust and fingerprints. Before cleaning, turn off
the system and unplug the power cord.
• To remove dirt or dust, wipe the component with a soft, dry, lint-free cloth.
• To remove stubborn dirt or stains, moisten a soft cloth with water and a neutral detergent. Then wipe the
component and dry it with a dry cloth.
Caution
Never use wax, alcohol, benzene, thinner, or other chemical detergents. These can damage components.
Adjusting the Screen Length
You can adjust how far the screen comes down when you open it. The screen is factory-set to come down 55
inches, but you can set it to come down as far as 64 inches, with a 12-inch black drop at the top.
Note
If you change the position of the screen, you’ll have to reposition the image. See page 56 for instructions.
1 Make sure the MAIN menu is displayed on the remote control. If necessary, press the MAIN button.
2 Press the
PAGE button to display additional components.
3 Press the button to the right of
PROJ to select the projector menu.
4 Use the following commands to raise and lower the screen, and to stop it at the desired position:
•
S-UP to raise the screen
•
S-DWN to lower the screen
When the screen comes to a stop, press
S-DWN again to lower it beyond the current stop-position.
You can bring it down as far as the maximum length set by the adjustment screw described in “Manual
Screen Adjustment” on page 55.
•
S-STP to stop the screen
5 Once the screen is positioned where you want it, press
S-SET to set the screen position.
55 inches 64 inches
To Next Page
Loading...
