24
3 To begin playing the CD, press the play button.
Note
To avoid interrupting CD playback, don’t switch sources. If you select a different source (such as CABLE or SAT), the CD will
stop playing. It will start over from the beginning when you resume playback.
Using Basic Playback Functions
While you’re listening to a CD, you can use the following buttons and the numeric keypad to control playback:
• To play a specific track on the CD, use the numeric keypad on the remote control. For example, to select
track 3, just press the
3 button. To select track 21, press 2 followed by 1. After pressing the buttons, wait a
moment for the selection to be transmitted, or press
SEL (Select) to transmit your selection right away.
You can also skip between tracks by using the fast-rewind or fast-forward button. To advance to the
next track, momentarily press and release the button without holding it. To go to the previous track,
press the button twice (the first time returns you to the beginning of the current track).
• The current track and elapsed time are indicated on the AV controller screen.
If the projector is on, you can also display the track and time information on the projection screen by
pressing the
INFO button. Each additional time you press the INFO button, the displayed information
changes (both on the AV controller and on the projection screen) as follows:
Track time elapsed o Track time remaining o Total time elapsed o Total time remaining o Display off
• Press and hold the fast-rewind or fast-forward button to move quickly through a track. Each time
you press and hold the button, the speed changes as follows:
2× o 4× o 6× o 8× o 2×
To return to normal playback, press the play button.
• Press the pause button to stop the music temporarily. To resume playback, press play or pause.
• Press the stop button when you’re done listening to the CD.
Play button
Fast-forward/skip forwardFast-rewind/skip backward
Stop
Play
Pause
Time elapsed/time remaining
To Next Page
Loading...
