Epson EPL-5500 - Fusing Unit Removal

3.2.3.6 Fusing Unit Removal
1. Open the top cover. (Refer to Section 3.2.3.3.)
2. Remove the image transfer unit. (Refer to Section 3.2.3.2.)
3. Remove 1 screw (#5), and remove the drive tension section of the fusing unit.
4. Remove the transport gear.
5. Release the hook of the spring and remove the drive gear section of the fusing unit.
ASSEMBLY POINTS
When rehooking the spring, be sure to hook it at the correct position.
6. Remove 4 screws (#5), and remove fusing guide plate.
drive gear section
of the Fusing unit
drive transport
gear
hook of the
spring
drive tension section
of the Fusing unit
Figure 3-15. Gear and Spring Position
Figure 3-16. Removing the Fusing Guide Plate
Disassembly and Assembly EPL-5500 Service Manual
3-12 Rev. B