Epson FX 1170 - B/W Dot-matrix Printer - Removing the Home Position (HP) DETECTOR; Removing the Platen Gap (PG) DETECTOR

REV.-A
3.2.5.8 Removing the Home Position (HP) DETECTOR
c
.,.%
,>
[STEP 11
Remove the PAPER GUIDE ASSEMBLY, top cover, front cover, paper eject cover, and tractor unit.
(See Section 3.2.1.)
[STEp 21
Remove the clip of the DETECTOR, HP. Remove the detector.
[STEp 31
Disconnect the LEAD, HP from the DETECTOR, HP.
[STEP 11
[STEP 21
[STEP 31
[STEP
41
[STEP 51
[STEP 61
Remove the PAPER GUIDE ASSEMBLY, top cover, front cover, paper eject cover, and tractor unit.
(See Section 3.2.1.)
Remove the PANEL UNIT. (See Section 3.2.2.)
Remove the HOUSING ASSEMBLY, UPPER. (See Section 3.2.4.)
Remove the PRINTER MECHANISM. (See Section 3.2.5.)
Remove the two clips of the DETECTOR, PG attached to the LEFT FRAME of the PRINTER
MECHANISM. Remove the detector.
Disconnect the LEAD, PG from the DETECTOR, PG.
i!-
Figure 3-18. Removing the DETECTOR, HP
3.2.5.9 Removing the Platen Gap
(PG) DETECTOR
Figure 3-19. Removing the DETECTOR, PG
3-18