Epson L550 - Transporting the Product

❏ Do not press the surface of the scanner glass with any force.
❏ Be careful not to scratch or damage the surface of the scanner glass, and do not use a hard or abrasive brush to clean
it. A damaged glass surface can decrease the scan quality.
Cleaning the interior of the product
To keep your print results at their best, clean the roller inside by using the following procedure.
!
Caution:
Be careful not to touch the parts inside the product.
c
Important:
❏ Be careful to keep water away from the electronic components.
❏ Do not spray the inside of the product with lubricants.
❏ Unsuitable oils can damage the mechanism. Contact your dealer or a qualified service person if lubrication is
needed.
A
Make sure that no warnings or errors are indicated in the control panel.
B
Load several sheets of A4-size plain paper in the rear paper feed.
C
Press r to enter the copy mode.
D
Press one of the x buttons to make a copy without placing a document on the scanner glass.
E
Repeat step 4 until the paper is not smeared with ink.
Transporting the Product
If you move the product some distance, you need to prepare it for transportation in its original box or one of a similar
size.
c
Important:
❏ When storing or transporting the product, avoid tilting it, placing it vertically, or turning it upside down;
otherwise ink may leak.
❏ When storing or transporting an ink bottle after removing its seal, do not tilt the bottle and do not subject it to
impacts or temperature changes. Otherwise, ink may leak even if the cap on the ink bottle is tightened securely. Be
sure to keep the ink bottle upright when tightening the cap, and take measures to prevent ink from leaking when
you transport the bottle.
A
Remove all paper from the rear paper feed and make sure the product is off.
User’s Guide
Maintaining Your Product and Software
92