REV.-A
3.2.4 Removing the Printer Mechanism
1.
2.
3.
4.
5.
Remove the upper case, as described in Section 3.2.2.2.
Remove the CB
(M3
X 6) screws that attach the
FFC
holding plate to the shield plate. Remove the
FFC
holding plate.
Disconnect the 2 FFCS from connectors
CN3 and CN4 on the drive board. Disconnect the cables
for
thefollowing
C060 DRV board connectors: CN5 (white, 2-pin);
CN6
(white, 5-pin); CN7 (black,
5-pin);
CN8 (white, 2-pin); CN9 (black, 2-pin); CN 10 (black, 3-pin); CN 11 (blue, 2-pin); and CN 12 (white,
3-pin).
Remove the
CBB(C)
(M3
X 6) screws that secure the printer mechanism to the shield plate. Remove
the right shield plate.
Remove the three
CBB(C)
(M4
X 14) screws that secure the printer mechanism to the lower case.
Remove the printer mechanism.
Right Shield Plate
CBB(C)
(M4 X 14)
r L----o, ,
—-
, ,
I
1
r
I
“1
(-IJ
I
1
wB-
—
—
Figure 3-10. Removing the Printer Mechanism
I
Assembly and Adjustment Note
1
After replacing the printer mechanism, you must adjust the bidirectional print position to ensure that
bidirectional printing is correctly aligned. (See Section 4.2.)
3-9
To Next Page
Loading...
