1-8
Setting Up the Printer
R4C3730
Rev. C
A5 size CHAP1.FM
8/23/99 Pass 0
L
Proof Sign-off:
<Crestec> _______
<Kimura> _______
<Crestec> _______
6. Remove the new ribbon cartridge from the package. Remove
the separator from the middle of the ribbon cartridge and
discard the separator. Then turn the ribbon-tightening knob
in the direction of the arrow to remove any slack in the ribbon.
7. Hold the cartridge with the ribbon-tightening knob up. Fit
the two front notches of the ribbon cartridge over the small
pegs on each side of the printer as shown below. Then lay the
cartridge flat.
separator
ribbon-tightening knob
New02.eps
1-4.eps
To Next Page
Loading...
