Width 90 to 304.8 mm (3.5 to 12.0 inches)
Length 70 to 420 mm (2.8 to 16.5 inches)
Thickness
single sheets
multipart forms
0.065 to 0.19 mm (0.0025 to 0.0074 inch)
0.12 to 0.49 mm (0.0047 to 0.0192 inch)
Weig ht
single sheets
multipart forms
52.3 to 157 g/m² (14 to 42 lb)
40 to 58 g/m² (10 to 15 lb)
Quality
single sheets Plain paper and recycled paper
multipart forms Carbonless or back carbon multipart forms with a line of
glue at the top or the side of the form
Copies 1 original + 6 copies
Continuous paper
See also “Multipart forms” on page 117 for detailed information on the specifications for
continuous multipart forms.
❏ The sprocket hole must be a circle or notched circle.
❏ The holes must be cleanly cut.
❏ If the horizontal and vertical perforations are crossed, the shaded area below should not be
printed on. Uncrossed perforations do not have this restricted area.
A:
B:
1.
2.
28 mm (1.1 inches)
3 mm (0.12 inch)
vertical perforation
horizontal perforation
LQ-690II/LQ-690IIN User’s Guide
Product Information 115
To Next Page
Loading...
