42
5. Slide the edge guide against the paper, then close the feeder guard.
6. Do one of the following to select the size and type of paper you just loaded on the product LCD
screen:
• To use the existing settings, press the OK button.
• To change the settings, press the up or down arrow button to select Change and press the OK
button. Select the paper size and press the OK button, select the paper type and press the OK
button, then press the OK button again to confirm the settings.
Note: To prevent the paper setup screen from appearing automatically when you load paper, turn off
the Paper Configuration setting in the Setup menu. (This will also disable AirPrint.)
To Next Page
Loading...
