Connecting to a Projector on a Network and Projecting
14
Connecting to a Projector on a Network and Projecting
Operating the Projector
Before connecting, put the projector into connection standby status.
Make sure the projector network settings are complete, and the projector
is connected to network equipment such as a network hub via a
commercially available network cable.
Procedure
A Press the [t] button on the remote control to turn the power
on.
B Press the LAN button on the Remote Control.
The LAN standby screen is displayed.
Operating the Computer
In the following explanations, unless otherwise noted, Windows screen
shots are used. You see the same screens even when using Macintosh.
Procedure
A Start EasyMP Network Projection.
For Windows
Select Start - Programs (or All Programs) - EPSON Projector -
EasyMP Network Projection.
For Macintosh
Double-click the Applications folder of the hard drive volume in
which EasyMP Network Projection is installed, and then dou-
ble-click the EasyMP Network Projection icon.
B Select "Advanced Connection Mode" and then click "OK".*
The projector search results are displayed. Because this projector
always connects using Advanced Connection Mode, Set the select-
ed Connection Mode as the default mode for future connections
is always selected.
* Cannot connect to the projector in Quick Connection Mode.
C Select the projector you want to connect to, and then click
"Connect".
If the projector you want to connect to is not displayed in the search
results, click the Automatic search button. The search takes about
30 seconds.
For details on the connection screen, see "Using the Connection
Screen".s p.15
To Next Page
Loading...
Need help?
General