Slideshow Basic Operations
49
Slideshow Basic Operations
Slideshow lets you play back and project image files stored on USB
storage devices and digital cameras.
This section explains the basic operations for Slideshow.
Although the following steps are explained based on the Remote Control,
you can perform the same operations from the projector’s Control panel.
Starting and Closing Slideshow
Starting Slideshow
Procedure
A Switch the projected image to USB.
B Connect the USB storage device or digital camera to the
projector.
Slideshow starts and the file list screen is displayed.
Closing Slideshow
Procedure
To close Slideshow, disconnect the USB device from the USB(Ty-
peA) port on the projector. For digital cameras, hard disks, and so
on, turn off the power to the device and then disconnect.
q
• You can also connect a memory card to the projector by loading it in a USB
card reader. However, some card readers may not be compatible.
• When the following screen (Select drive screen) is displayed, press the
[ ][ ][ ][ ] buttons to select the drive you want to use, and
then press the Enter button.
• To display the Select drive screen, position the cursor on Select drive in the
top half of the file list screen, and then press the Enter button.
Slideshow Basic Operations
The following describes the procedures for playing images using
Slideshow, and projection operations.
To Next Page
Loading...
Need help?
General