Troubleshooting
60
Cannot connect in Advanced Connection Mode
The Slide Show does not display when the multi-screen display function is used.
Was the network adapter used selected correctly with
EasyMP Network Projection?
If the computer has multiple LAN environments, it cannot connect unless the network adapter is
selected correctly. When using a computer running Windows, start EasyMP Network Projection, and
select the network adapter you are using from Set options - Switch LAN.s p.39
Is the firewall turned off, or has the firewall been
registered as an exception?
When you do not wish to turn off the firewall or register the firewall as an exception, make the
necessary settings to open the ports.
The ports used by EasyMP Network Projection are "3620", "3621", and "3629".
Is the network cable connected correctly? Check that the network cable is connected correctly. Reconnect it if it is not connected or not
connected properly.
Check Remedy
Are the connection denial functions, such as MAC Address
restrictions and port restrictions, set correctly at the
access point?
Set the projector to allow connections from the access point.
Are the IP address, the Subnet Mask, and the Gateway
Address for the access point and the projector set
correctly?
When not using a DHCP, adjust each setting.
Are the access point and the projector's subnet different? Select Manual search from EasyMP Network Projection, specify the IP address, and connect.
s p.33
Check Remedy
Are you using PowerPoint 2002 or an earlier version?
For Windows
To set and use two or more virtual displays, use PowerPoint 2003 or later, or limit the number of
virtual displays to one before displaying the Slide Show.
Check Remedy
To Next Page
Loading...
Need help?
General