Connecting to a Projector on a Different Subnet
32
Connecting to a Projector on a Different Subnet
By default, this application only searches for projectors on the same
subnet as the computer. Therefore, even if you perform a search for
projectors on the network, ones on a different subnet will not be found.
You can, however, identify and connect to a projector on a different
subnet as follows:
• Specify either an IP address or Projector Name and perform a search.
The IP Address can be input directly. Also, provided the Projector
name to be connected has been registered on the DNS server, you can
perform a search simply by inputting that Projector name.s p.33
• Performing a search based on a Profile
Once you have performed a search for a projector on a different subnet
by specifying either an IP Address or a Projector name, you can save
the search as a Profile with an easy-to-remember name, and then use
that Profile whenever you subsequently want to search for a projector
on a different subnet.s p.34
To Next Page
Loading...
Need help?
General