Epson PowerLite S5 Series User Manual

70 Fine-tuning the Projector
Starting the Projector with a Password
When the password function is enabled, you see this screen when you
turn on the projector:
Use the numeric buttons on the remote control to enter the password.
Once you have entered the password correctly, the password screen
closes, and projection begins.
If the password is not correct, you see the message
Wrong password.
Please try again.
If you enter an incorrect password three times in
succession, you see the message
The projector’s operation will be
locked. Request code xxxxx
and the projector switches to standby
mode for approximately 5 minutes. Write down the request code.
Then disconnect the projector’s power cord from the electrical outlet,
reconnect it, and turn the projector back on.
When you see the Password Protect Release screen again, you can try
to enter the correct password.
If you have forgotten the password, contact Epson with the request
code number that appears in the Password Protect Release screen for
assistance. See “Where To Get Help” on page 93.
If you enter an incorrect password 30 times in succession, the
projector remains locked and you must contact Epson to have the
projector serviced.

Epson PowerLite S5 Series Specifications

General

Resolution	800 x 600 (SVGA)
Contrast Ratio	400:1
Weight	2.7 kg (6.0 lbs)
Projection System	3LCD, 3-chip technology
Lamp Type	170 W UHE
Lamp Life	3000 hours (Normal Mode)
Zoom Ratio	1.35x
Projection Size	30" to 300"
Input Ports	Composite Video (RCA), S-Video (Mini DIN 4-pin), Audio (Stereo Mini Jack), VGA (HD D-sub 15-pin)
Output Ports	VGA (HD D-sub 15-pin)
Noise Level	37 dB (Normal Mode), 30 dB (Low Brightness Mode)