Fine-tuning the Projector 65
■ Language
Select the language to be used for the projector menus.
4. When you’re finished, press
Esc or Menu.
Viewing Lamp Usage and Other
Information
Use the Info menu to view information about the display settings of
your computer and the number of hours the lamp has been used.
1. Press the
Menu button and select the Info menu. You see a screen
displaying the following information:
■ Lamp Hours
Displays the number of hours the lamp has been used. The
life span of the lamp ranges from about 3000 hours in
High
brightness mode to about 4000 hours in
Low brightness
mode. If the number shown is close to 3000 or the
information is displayed in red, make sure you have a spare
lamp handy.
■ Source
Displays the input source currently being projected.
■ Input Signal (computer, RGB video, and component video)
Displays the input signal setting.
■ Resolution (computer, RGB video, and component video)
Displays the input resolution.
■ Video Signal (composite and S-Video)
Displays the video signal format.
■ Refresh Rate (computer, RGB video, and component video)
Displays the refresh rate.
■ Sync Info (computer, RGB video, and component video)
Provides information that may be needed by the service
technician.
note
You can make changes to
many of the signal settings on
the Signal menu. See page 58
for details.
note
The lamp usage timer doesn’t
register until you’ve used the
lamp for at least 10 hours.
To Next Page
Loading...
Need help?
General
